Service Tel:+86-371-53762053
Tel/whatsapp/wechat:+86-13674998188 (24 hours online)
E-mail:
zhengzhouyuxi@yuximachine.com
Add:Economic And Technological Development Zone, Zhengzhou, Henan, China (Mainland)
Yuxi Machinery is a professional manufacturer of shredders. It also has a lot of experience in the use of motors and fault prevention.
The following teaches you how to eliminate the motor failure experience of mini aluminum can shredder:
1. The mini aluminum can shredder bearing wears due to long-term operation, causing contact between the stator and the rotor, resulting in damage to the surface of the core, resulting in a short circuit between the silicon steel sheets of the shredder, and the iron loss of the motor becomes large, so that the motor temperature The rise is too high. In the face of such failures, first use tools such as fine boring to remove burrs and other materials, solve the short-circuit connection between the silicon steel sheets, clean them and apply high-quality insulating varnish, then heat and dry.
Second, the mini aluminum can shredder when the old windings are removed, the force is too large, so that the stolen groove is skewed and flared outward. In this case, tools such as needle-nosed pliers and wooden hoes are used to trim the teeth, and hard insulating materials such as green paper and rubber wood are added between the gap-free silicon steel sheets which are difficult to reset.
Third, the mini aluminum can shredder due to moisture and other external environmental climatic causes of iron core surface corrosion. At this point, it needs to be sanded and cleaned, and then coated with insulating varnish.
Fourth, around the group grounding to produce high heat burnt iron core or tooth. The deposit can be removed by a tool such as a chisel or a scraper and dried with an insulating varnish.
5. Mini aluminum can shredder The iron core and the base are loose. The original positioning screws should be tightened. If the positioning screw fails, the positioning hole can be re-drilled on the base and screwed into the screw.