Service Tel:+86-371-53762053
Tel/whatsapp/wechat:+86-13674998188 (24 hours online)
E-mail:
zhengzhouyuxi@yuximachine.com
Add:Economic And Technological Development Zone, Zhengzhou, Henan, China (Mainland)
With the development of society, all kinds of pollution come from all kinds of pollution, pollution is getting more and more serious, the requirements for environmental protection and emission reduction are getting tighter, and the improvement of the environment is in the brow. We will produce domestic garbage in our daily life, and industrial development will produce industry.
Garbage, construction, road construction will produce construction waste, catering tourism will produce a lot of white disposable garbage and kitchen waste, recycling industry recycles a variety of waste, most of the garbage can be crushed and reused, The waste shreddermachine has strong crushing ability and wide use.
The machine can effectively shred waste into uniform materials and can be used to crush various waste products.
The waste shredder machine is widely used, and daily maintenance is also in place. The shredder is in a bad working environment for many years. Sometimes there are different degrees of small defects. Some problems are not obvious. They are small defects. Easy handling, mechanical equipment, need to pay attention to maintenance and maintenance in use, can extend the service life of the equipment, if not carefully observed, it is difficult to find the existence of these small defects, long-term push-off, will cause serious damage to the shredder It wastes time, money, energy, and delays in production, efficiency, and production.
If abnormal shredder machine is found in production, it must be stopped to check whether the shaft of the equipment is damaged. If not, it means that the butter on the shaft is too small, resulting in the shaft and gear. There is an abnormal increase in the friction between the two. This small problem needs to be dealt with in time to avoid becoming a big problem. The user needs to regularly add butter to the shaft to prevent the shaft from being damaged due to the poor smoothing effect.
The waste is found in the production process. When the shredder machine is inefficient, the machine should be shut down immediately. It is very likely that the gap between the cutters in the inner cavity of the device caused by the harder material is larger. This problem belongs to normal grinding. Just check that the cutter head is not worn.
If it is not necessary to change the tool, just between the blades. Adjust the gap and you're done.