Scrap metal shredder price

In the process of using the scrap metal shredder price, we must also pay attention to it. The scrap metal shredder price is usually divided into ordinary processing, multi-knife structure, and spiral surface structure in use. These three feeding methods have slanted mouths. Feeding and flat feeding. In terms of use options, flat feed is generally used for shredding long logs, and diagonal feed is generally used for short logs and skins.

What problems should be paid attention to when the dual-shaft shredder is turned on to better ensure the use of the shredder? The following content will be explained in detail to you. The following can help you use it better and more correctly. Double shaft shredder product.

One: Turn on the motor. The chamber motor runs in no load. Observe the operation of each part of the shredder. Only after checking that all parts are operating normally, can the load run.

Two: Observe whether there are stuck magnetic and friction sounds. If there is, you should stop working immediately and check the cause of the failure.

Three: The sieve should be installed firmly, sealed, and there should be no leakage, and the sieve frame should be fastened.

Four: If abnormal noise, discharge blockage, or overheating of the bearing or motor are found during the work, the feeding should be stopped and the machine should be stopped for inspection to eliminate the fault.

Five: After the work is completed, it should be run empty for 2-3 minutes. After the materials in the machine are completely eliminated, the crusher and fan can be stopped.

Six: Safety must be strictly guaranteed during operation. It is strictly forbidden to increase the speed of the shredder at will. Check the cotter pin on the pin frequently. If it is excessively worn or cracked, it should be replaced immediately.