Products

Shredder Machine

Scrap Metal Shredder Waste Tire Shredder Waste Car Shredder Scrap Aluminum Shredder Single Shaft Shredder Domestic Garbage Shredder Plastic Crusher Medical Waste Shredder

Waste Metal Recycling Line

Scrap Car Crushing Separating L Scrap Metal Crushing Plant AC Radiator Recycling Line Waste Rotor Recycling Line Scrap Car Engine Crushing Line Medical Waste Recycling Line

Optional Equipments

Central Dust Collector Magnetic Separator Machine Eddy Current Sorting Machine Scrap Metal Crusher Metal Shredder Crocodile Shear Waste Copper Cable Wire Recycli Hydraulic Metal Baler Machine

Tire Recycling Machine

Waste tire recycling machinery

Contact Us

Service Tel:+86-371-53762053
Tel/whatsapp/wechat:+86-13674998188 (24 hours online)
E-mail: zhengzhouyuxi@yuximachine.com
Add:Economic And Technological Development Zone, Zhengzhou, Henan, China (Mainland)

Skype: yuxi.zhengzhou

Position : Home > News >

Regarding the surrounding and sticky materials, we can adjust the speed of the cutter slower, such as shredding woven bags, waste wires and cables, etc. Immediately adjusting the speed of the cutter of the shredder equipment can increase the bite strength and sufficient Shredding can also shred these surrounding materials at the fastest speed. Adjusting the speed of the shredder cutter according to different materials is a basis. Sometimes it can increase the output value, but also prevent unnecessary wear of the cutter and extend the life of the shredder.

Reason analysis believes that the high temperature of the rotor bearing of the shredder may have the following aspects: the bearing gap is too small, which makes the bearing temperature too high. Improper selection of lubricating oil quality, too large viscosity or too low viscosity to form an oil film, which can cause the bearing temperature to rise too high. Especially when the oil viscosity is large, it not only increases the internal friction between the lubricating oil molecules, but also increases the friction between the oil and the metal, resulting in excessive heat.

Improper installation, the rubber plate and the rubber plate are too thick, the rigidity is too large, and the deflection is not enough, causing bearing competition, intense friction, and excessive heat. The amount of oil is too large to reach or exceed the center of the bottom ball or roller, which does not meet the requirements of oil bath lubricated rolling bearings, and is too hot during constant stirring. Because there is no heat in the shell, the heat cannot be released in time and cannot be balanced at the required temperature. Therefore, the temperature of the rotor bearing is high.

Get a Free Quote Now!

Tel：0086-0371-53762053

Tel：0086-13674998188

Whatsapp：0086 13674998188

Wechat:8613674998188

Skype：yuxi.zhengzhou

E-mail：zhengzhouyuxi@yuximachine.com