Products

Shredder Machine

Scrap Metal Shredder Waste Tire Shredder Waste Car Shredder Scrap Aluminum Shredder Single Shaft Shredder Domestic Garbage Shredder Plastic Crusher Medical Waste Shredder

Waste Metal Recycling Line

Scrap Car Crushing Separating L Scrap Metal Crushing Plant AC Radiator Recycling Line Waste Rotor Recycling Line Scrap Car Engine Crushing Line Medical Waste Recycling Line

Optional Equipments

Central Dust Collector Magnetic Separator Machine Eddy Current Sorting Machine Scrap Metal Crusher Metal Shredder Crocodile Shear Waste Copper Cable Wire Recycli Hydraulic Metal Baler Machine

Tire Recycling Machine

Waste tire recycling machinery

Contact Us

Service Tel:+86-371-53762053
Tel/whatsapp/wechat:+86-13674998188 (24 hours online)
E-mail: zhengzhouyuxi@yuximachine.com
Add:Economic And Technological Development Zone, Zhengzhou, Henan, China (Mainland)

Skype: yuxi.zhengzhou

Position : Home > News >

The metal shredder is composed of tools, spindles, bearings, reducers, motors, and chassis. The bearings are fixed on the spindle, and the spindle is driven by the motor to shred scrap metal. The bearings are used frequently. If you do not pay attention to maintenance and maintenance , It will cause bearing damage and affect equipment work. Now we will introduce how to maintain the metal shredder.

1. Add lubricating oil to the bearing regularly to ensure its cleanliness and avoid high temperature damage to the bearing;
2. Check whether the bearing is damaged before and after get off work, and stop the machine for repair immediately if it fails;
3. The bearing of waste shredder is cleaned regularly, divided into rough washing and fine washing for cleaning, and a metal grid is placed at the bottom of the container; in the rough washing, use a brush in the oil to remove the grease or binder; in the fine washing, you must be careful carry the bearing slowly in oil;
4. After cleaning the bearing of the shredder, apply butter on the bearing of the shredder and seal it well;
5. When the bearing is disassembled and inspected, records should be made. In addition, confirm the amount of remaining lubricating oil, and then clean the bearing;
6. If noise or noise is found in the equipment during work, it should be shut down for maintenance to see if the bearings are damaged.

Bearing is an important part of the metal shredder. Once damaged, it will not be able to operate. Moreover, the bearings on the shredder are relatively large, expensive, and inconvenient to assemble. Daily maintenance should be done to ensure that it can be produced without problems for a long time.

Get a Free Quote Now!

Tel：0086-0371-53762053

Tel：0086-13674998188

Whatsapp：0086 13674998188

Wechat:8613674998188

Skype：yuxi.zhengzhou

E-mail：zhengzhouyuxi@yuximachine.com